"When they go bad the engine is toast"

Ask the A&Ps

Lean of peak is causing odd vibrations in a Commander, and the hosts discuss proper troubleshooting. Plus carb heat on the ground, dehydrators, and parts no longer manufactured. Email [e-mail] for a chance to get on the show.

Full notes below.

Chip said his mechanic is concerned about lean of peak because we don’t know the actual temperature at the valve, as the temperature is taken downstream. Colleen makes the point that EGT temperatures are fine because it’s well below the valve limit temperature. Mike said valves burn only when they don’t seat properly. They shed their heat through physical contact with the seat at the cylinder head. They also shed it through the valve stem. Detonation once flying lean of peak isn’t a concern. It’s getting to that point that’s the biggest risk. Paul suggests that once you know the fuel flow at your desired power setting you can lean straight to that fuel flow and not worry about EGT or CHT until it’s set and stable. Chip is also concerned about a vibration in the floor of his Rockwell Commander. Mike suggests he do some testing to help isolate the issue. If it goes away at certain rpms, then it suggests that it’s an engine-based issue. At a constant rpm but with changing pitch, it suggests a potential airflow or airframe source.

Frank is questioning the logic of the Luscombe handbook. It says to put the carb heat on for takeoff. It’s also placarded that way on the panel. The hosts can’t figure out why this would be required. The hosts suggest he ignore the handbook and operate as he would in other airplanes, in part because the engine would be breathing unfiltered air while on the ground.

Bill has a Cessna 180 on floats with an O-470-50 engine. For the last few months he hasn’t been flying as much and he wants to preserve the longevity of the engine. He is looking for details on engine dehydrators and whether they actually work. Colleen looked through some research and found that those who had done some side-by-side testing had found good results. Mike said Tanis found that people who ran their heaters all the time were causing corrosion, but that if they use engine dehydrators they are fine to run the heater all the time. In other words, they seem to work.

Mark is pushing back on airport naysayers that tell him autofuel is dangerous. He flies airplanes with older, small Continentals, and with all the info that has come out on the transition away from 100LL, he’s wondering if he should be worried. Mike said running on autofuel is the best thing he can do for his engine. People tell Mark he has to run at least half low lead. Mike said they’ve never seen issues with low compression engines running on autofuel. Mark flies from an airport a mile high, and locals are also telling him that vapor lock is also an issue.